An item was added to cart!
Everlights Classic White LED Starter Kit
The Everlights Classic White LED Starter Kit is everything you need to get started on your EverLights installation!
DIY Tip: This system is only ON or OFF. No control box, sequencing, or App available. Often installed on commercial projects.
PRODUCT DESCRIPTION
The EverLights Classic Warm White LED Starter Kit is everything you need to get started on your EverLights installation!
Includes:
- (1) Waterproof Power Supply
- (2) Y-split Connectors
- (4) Mounting Screws
- (180') Layout Tape
- (2) Drill Bits
- (30) Butt Splice Heat Shrinks (15 connections worth)
- (50') Black Unlit 2-Wire
Classic LEDs are always warm white and can only be controlled with a switch, smart outlet, or home automation.
Use of this product may require maintenance, including but not limited to, periodic replacing of light bulbs.
MATERIAL LIST ADDERS:
Select the items dropdown variation first before you tick the checkbox. To save time simply add any additional items needed from your material list below, then change the quantities in the side cart when it slides open.
DIY ESTIMATING TIPS
MEASURE ALL EVES AND GUTTERS
& always round up
HOW TO MEASURE PROJECT: VIDEO
Timelaps Install of channel & to gutters - Time: 00:38
The 3 Must Follow Rules For A Proper Install
If all else fails, follow these rules and you will be OK.
1) Never cut any wires with the lights powered. The lights are powered anytime they are plugged into a power source, whether the lights are on or not. Always install with the lights unplugged from all power sources.
2) Connect like to like wires. The wire labeled “EverLights” only connects to other wires labeled “EverLights”. Same deal for the other two wires.
3) Keep the direction of the lights constant. Every light has an input and output. They must always connect in to out. The back of every light is labeled and includes an arrow. Ensure all arrows are pointing in the same direction.
Failure to follow these rules will result in an increased failure rate because of improper power flow.
TERMINATING WIRE RUNS
Wherever you decide to terminate a run of lights it is very important to properly protect the exposed wires. There are multiple methods to coat the end of the wires, but generally electrical tape, silicone, or liquid electrical tape work best. The purpose of coating the wires is to prevent the positive and wires from coming in contact through water, touching against a piece of metal, or any other conductive material.
A short in the lights will cause improper function and potential damage to the lights in the system. To further protect against a potential short, snip the positive wire an inch shorter than the other wires before coating.
PRODUCT REVIEWS
Contact Us
We accept
